Oh Yea - GRM 2010
We go back again in 2009! (It's about time too...)
Returning to the GRM Challenge in 2006
Scirocco.org Members compete in the $2004 GRM Challenge
Ah, air cutting the lower shock bolt free. It's really not a happy fun situation.  Oh, Brians feet are out in the drive way because his garage is so spacious.
Ah, air cutting the lower shock bolt free. It's really not a happy fun situation. Oh, Brians feet are out in the drive way because his garage is so spacious.
Viewed: 1123 times.

Here's the result.  Give me "German Engineers I'd Like To Strangle" for $100 Alex.  One cut bolt...other side is next.
Here's the result. Give me "German Engineers I'd Like To Strangle" for $100 Alex. One cut bolt...other side is next.
Viewed: 1088 times.

I think we'd best get to work here actually...there's a lot more to do, and we're running out of time!! ;-)
I think we'd best get to work here actually...there's a lot more to do, and we're running out of time!! ;-)
Viewed: 1131 times.

In order to avoid running into the ITB's, a new front coolent pipe had to be fabricated.
In order to avoid running into the ITB's, a new front coolent pipe had to be fabricated.
Viewed: 1085 times.

The inside view of the coolent pipe.  Nice "over-welding" Brian,  that'll hold up the motor using a coolent hose in the unlikely event that all 4 motor mounts fail... :-)
The inside view of the coolent pipe. Nice "over-welding" Brian, that'll hold up the motor using a coolent hose in the unlikely event that all 4 motor mounts fail... :-)
Viewed: 1130 times.

And this is how it'll look installed..we'll have to trim the pipe back a bit.
And this is how it'll look installed..we'll have to trim the pipe back a bit.
Viewed: 1101 times.

Ok, I'm getting a bit tired of working on this panel, I'm finishing it tonight.  Word.
Ok, I'm getting a bit tired of working on this panel, I'm finishing it tonight. Word.
Viewed: 1067 times.

Yep, happy welding camper here...24ga *might* be a little too thin.  Luckily, the Easy Bake(tm) welder goes real low.
Yep, happy welding camper here...24ga *might* be a little too thin. Luckily, the Easy Bake(tm) welder goes real low.
Viewed: 1107 times.

Pretty? No.  Welded?  Yep.  Strong?  Enough.
Pretty? No. Welded? Yep. Strong? Enough.
Viewed: 1094 times.

It's not the heat or light from welding, it's the burning release of the VOC's as the paint flames up that's so irritating...ha! :)
It's not the heat or light from welding, it's the burning release of the VOC's as the paint flames up that's so irritating...ha! :)
Viewed: 1125 times.

Ok, we need an air box...probably. Brian bends one up.
Ok, we need an air box...probably. Brian bends one up.
Viewed: 1104 times.

I weld it up a bit, he's going to solder the rest of the seam closed later. We expect to use plumbing fitting for the tubes. Recent emails from Brian has me worried that this plan is in jeopardy.
I weld it up a bit, he's going to solder the rest of the seam closed later. We expect to use plumbing fitting for the tubes. Recent emails from Brian has me worried that this plan is in jeopardy.
Viewed: 1136 times.

Powered by Gallery v1 RSS


© 1998-2004 Drazan Enterprise